Contents
INTRODUCE
How do I make a cat6A Ethernet cable if I don’t have a crimping tool on hand? Many people will say to cut off the excess cable with scissors. But this creates other new problems.The easiest way is to use tool-less connectors.
Tool-less connectors have the following advantages over regular connectors.
First of all, it does not need to use a crimping tool , and it’ s easy to install, even without the annoying threading. Moreover, it has a metal housing which can be used as a shield, so his quality is very good, and it can be reused, saving you a lot of energy.
So even though it’s more expensive than a regular connector, trust me, it’s worth it!
Below, we show you how to make cat6A Ethernet cables with tool-less connectors.
VIDEO:How to make a Cat6A Ethernet cable with tool-less connectors?
RODUCT
STEPS: How to make Cat6A Ethernet cable with tool-less connectors?

STEP 1:
Insert the strain relief boot into the cat6 Ethernet cable.

STEP 2:
Measure about 30mm length of cable and mark on it.

STEP 3:
Strip the cable jacket with a wire stripping tool.

STEP 4:
Strip the shield braid and fold back the shield ground wire.

STEP 5:
Wrap the ground wire with the copper foil that comes with the tool-free connectors.

STEP 6:
Cut off the excess shielded braided wire.

STEP 7:
Separate the tangled wires and use the cut cable jacket to straighten the wires.

STEP 8:
Arrange the wires in the order of T568B And insert the wire groove.

STEP 9:
Cut off the excess wire.

STEP 10:
Align the slot and cover with the wire cap.

STEP 11:
Shut the outer housing.

STEP 12:
Tighten the strain relief boot.
The tool-free connector is installed.
These are steps on how to make a Cat6A Ethernet cable with tool-less connectors?! Hope it can help you!
you have any questions, please feel free to email sales@vcelink.com or send a message to WhatsApp: +86 18072806195