Brush wall plate is one of the easiest ways to keep your messy cables organized. And it’s so easy to install brush wall plate, you’ll only need a screwdriver to solve it in a few minutes.
What is a brush wall plate for? It lets terminated cables pass through to the intended device without the need to terminate cables in the wall. This reduces a lot of hassle for you and also reduces the chance of signal loss or unreliable connections.
Below, it gives the steps to install the brush wall plates in detail.
Youtube Tutorial: install brush wall plate
STEPS: install brush wall plate
Draw a 92mmx54mm hole in the wall. Slightly larger than your Low Voltage Box.
Drill holes in each of the four corners to dig.
Digging out the rectangle.
Put the wall plate mounting bracket on the wall.
Secure the top and bottom ports of the low pressure bracket with a screwdriver.
Place the brush wall plate on the wall
Tighten the top and bottom ports of the brush wall plate with a screwdriver.
Then screw the wall plate to the wall and tighten it with a screwdriver.
In this way, the ethernet brush plate is installed.
These are steps on how to install wall plate for cable! Hope it can help you!
WIf you have any questions, please feel free to email email@example.com or send a message to WhatsApp: +86 18072806195