Contents
Introduce
The network is developing more and more rapidly, the optical network cable is divided into Cat3, Cat5, Cat5e, Cat6, Cat6A, Cat7, Cat8, and the network cable will need to be used with RJ45 connectors.
RJ45 connectors are mainly used to connect NIC ports, hubs, switches and telephones and other devices, for field termination between devices or horizontal subsystems.
For cat8 cables, it has a larger diameter. And the ordinary RJ45 connector has smaller hole diameter. Therefore, in terms of operability and practicality, etc., are not as good as this type of cat8 keystone jack that does not require crimping tools.
Video
Product
Steps

STEP 1:
Insert cat8 Ethernet cable into strain relief boot.
Notice the arrow of the locking cap need to point forward.

STEP 2:
Strip off 30 mm of cat8 cable jacket.

STEP 3:
Fold back the shield ground wire.

STEP 4:
Cut away the aluminum foil.

STEP 5:
Fold down the aluminum foil

STEP 6:
Cut off the plastic film.

STEP 7:
Cut the center spline of the Network cable.

STEP 8:
Insert the wires into the wire groove of the RJ45 keystone jack.

STEP 9:
The wires are placed in the corresponding wire slots, according to the wire sequence of the T568B/568A.

STEP 10:
Cut off the excess core wire.

STEP 11:
Wrap the ground wire with the copper foil

STEP 12:
Cut off excess aluminum film under copper foil.

STEP 13:
Align the slots off the wire cap, cover the wire cap, and press the keystone jack.

STEP 14:
Tighten the strain relief boot.
The cat8 tool free keystone jack is installed.
These are steps on how to make a Cat8 Ethernet cable with tool free keystone jack?! Hope it can help you!
you have any questions, please feel free to email sales@vcelink.com or send a message to WhatsApp: +86 18072806195